Race Drone FPV Range Test Through Heavy Tree Corridor AKK 800mw VTX and FlySky i6X Radio

Excellent spot to test the video feed and radio control range. Really pushing the limit here, flying trough a thick tree corridor and trying to stay low and fast. I didn't have the best vantage point, I basically stood half way down the road and tried to be somewhat in line of sight, but the road curves so not quite possible. I was impressed with the results, barely any breakup. Started to get some bad breakup all the way down the one end at the paved entrance. Everything else was perfect ! Video shows both cameras, the onboard HD GoPro and also my FPV camera feed recorded with my goggles, so you can see the reception quality with the range. Using the AKK Tech Q3 VTX, switchable from 25mw to 800mw. I'm using 800mw here and my Eachine EV800D Diversity goggles with some aftermarket antennas. Aomway 5db RHCP antenna on the VTX and on my goggle B channel, and the Aomway 5db panel antenna on the A channel on my goggles. Radio is the FlySky i6X with micro A6B receiver on the quad via SBUS. Very basic, and very good !! YouTube - http://YouTube.com/JDogB1 AirVuz - https://www.AirVuz.com/user/FireBlade Instagram - https://www.instagram.com/JDogB1_FireBlade FPVBook - http://www.fpvbook.com/FireBlade Full open acro mode, accelerometer disabled. Quadcopter: Custom build 5" race quad using QAVR 220 upgraded frame. (thicker upper and lower plates, 3mm lower and 2mm upper, also upgraded fasteners and aluminum knurled standoffs) PDB: Matek 5-in-1 3-5s FC: OmniBus F4 Pro V2 Betaflight OSD ESC: DYS blheli_s 30A V2 DShot600 Motors: Emax RS2205 2300kv Blades: DalProp Cyclone T5050C FPV Camera: RunCam Owl Plus 2 16:9 2.1mm VTX: AKK Switchable Betaflight Q3 25mw to 800mw Batteries: Tattu 1550mah 95c 4s TX: FlySky i6x FPV Goggles: Eachine EV800D Antennas: TBS Triumph DVR Receiver: Eachine RC840 DVR Camera: GoPro Session 5 Quad total weight without battery: 451g Lipo battery weight: 171g (wrapped)