Baby Tooth Build Guide - DIY FPV Drone - Part 1

Today we are going to build a variant of KebabFPV's "baby tooth" FPV drone. Just what is a "baby tooth"? It is an ultralight FPV quad which typically runs on 1-2S batteries. It is small, light and very quiet when it flies. Most importantly, it offers a roller coaster flight experience similar to that of a larger, heavier quad. For more information about this build and a list of the materials I used, check out my detailed article: https://nuxnik.com/baby-tooth-build Table of Contents: 00:36 - Bill of Materials 01:47 - Frame Prep 04:00 - Flight Controller Prep 04:43 - Wiring up the RX 05:52 - Wiring up the VTX 06:41 - Wiring up the camera 07:46 - Heatshrink and Insulation 09:15 - Wiring up the power leads and capacitor 11:06 - Wiring up the motor wires 14:16 - RX Antennas 15:57 - Canopy assembly 18:06 - Finishing Touches 20:41 - Final Thoughts 21:17 - Subscribe I would like to thank KababFPV for the hard work that went into his creative design. If you haven't already subscribe to his channel: https://www.youtube.com/c/Kabab ...and while you're at it subscribe to my channel as well. For more builds check out my website: https://nuxnik.com